1、水沖洗：用大流量的水盡可能的沖洗掉系統中的灰塵、泥沙、脫落的藻類及腐蝕產物等一些疏松的污垢，以節約用藥量，降低清洗成本，為下一步的化學清洗做準備。
With a large flow of water to flush out the system as dust, sand, and the corrosion products falling algae and some loose dirt, to conserve drug, reduce the cost of cleaning, chemical cleaning for the next preparation.
2、殺菌滅藻：通過加入殺菌滅藻藥劑，殺死系統中微生物，并使設備內表面附著的生物粘泥剝離脫落。
By adding biocide agents, killing microorganisms in the system, and make the device attached to the surface of the biological slime stripping off.
3、除垢剝離：加入剝離劑、除垢劑、分散劑對系統內水垢、銹垢剝離解體后排出，還原一個潔凈的金屬表面。
Join stripping agents, detergents, dispersants after the system scale, rust peeling disintegration discharge, restore a clean metal surface.
4、鈍化或預膜：設備管道經過清洗后其金屬表面處于十分活躍的活性狀態，極易二次氧化銹蝕。A：若設備清洗后封存，則對設備進行鈍化處理；B：若設備清洗后投入使用，則進行預膜處理。以更好的保護潔凈的金屬表面防止氧化銹蝕。
After cleaning their equipment pipeline is very active metal surface active state, vulnerable secondary oxidation corrosion. A: If the equipment cleaning after sequestration, then the device passivation treatment; B: If after cleaning equipment put into use, the pre-film treatment. Better protection to prevent oxidation of the clean metal surface corrosion.
5、日常水維護：通過加入水處理藥劑，抑制水中菌藻生長，防止鈣、鎂離子結晶、沉淀最大限度的保持金屬表面清潔。
By adding water treatment chemicals, inhibit the growth of bacteria and algae in water to prevent calcium and magnesium ions crystallization, precipitation maximum to keep metal surfaces clean.